Crankshaft Position Sensor (1Az–Fe/1Az–Fse) Replacement - Toyota Avensis ZZT251 2003 Service And Repair Manual

CRANKSHAFT POSITION SENSOR (1AZ–FE/1AZ–FSE)
REPLACEMENT
1. REMOVE ENGINE UNDER COVER LH
2. REMOVE ENGINE UNDER COVER RH
3. REMOVE RADIATOR SUPPORT OPENING COVER
4. REMOVE ENGINE ROOM COVER SIDE
5. REMOVE FAN AND GENERATOR V BELT
6. REMOVE GENERATOR ASSY
SST 09249–63010
HINT:
Y
1AZ–FE: 14–105
Y
1AZ–FSE: 14–185
(b)
8. INSTALL CRANKSHAFT POSITION SENSOR
(a) Apply a light coat of engine oil to the O–ring on the crankshaft position sensor.
(b) Install the crankshaft position sensor with the bolt.
Torque: 9.0 N m (92 kgf cm, 79 in. lbf)
(c) Install the wire harness clamp.
(d) Install the connector clamp.
(e) Install the wire harness of the crankshaft position sensor to the the wire harness clamp bracket.
(f) Connect the crankshaft position sensor connector.
9. INSTALL GENERATOR ASSY
10. INSTALL FAN AND GENERATOR V BELT
SST 09249–63010
HINT:
Y
1AZ–FE: 14–105
Y
1AZ–FSE: 14–185
11. INSTALL ENGINE ROOM COVER SIDE
12. INSTALL RADIATOR SUPPORT OPENING COVER
13. INSTALL ENGINE UNDER COVER RH
14. INSTALL ENGINE UNDER COVER LH
AVENSIS REPAIR MANUAL (RM1018E)
IGNITION
(See page
(See page
(See page
7.
(a)
(a)
(b)
(c)
(c)
(d)
(e)
(d)
A77896
(See page
http://vnx.su
– CRANKSHAFT POSITION
SENSOR (1AZ–FE/1AZ–FSE)
19–20)
19–20)
(See page
(See page 10–26)
19–20)
REMOVE CRANKSHAFT POSITION SENSOR
Disconnect the crankshaft position sensor connector.
Remove the wire harness of the crankshaft position sen-
sor from the wire harness clamp bracket.
Remove the connector clamp.
Remove the wire harness clamp.
Remove the bolt, and then remove the crankshaft posi-
tion sensor.
19–20)
10–26)
18–17
1807L–01