Table of Contents
Advertisement
72–16
OVERHAUL
CAUTION:
Y
Wear safety gloves, because the cutting surface of the seatback frame and seat adjuster may
injure your hand.
Y
Work must be started more than 90 seconds after the ignition switch is turned to the LOCK posi-
tion and the negative (–) terminal cable is disconnected from the battery.
(The SRS is equipped with a back–up power source. If work is started within 90 seconds from
disconnecting the negative (–) terminal cable of the battery, the SRS may be deployed.)
HINT:
Y
The installation is in the reverse order of the removal. However, when there is a special point concern-
ing the installation, it is indicated.
Y
Use the same procedures on the RH side as on the LH side.
1.
REMOVE FRONT SEAT ASSEMBLY LH
(a)
Remove the headrest.
(b)
Using a screwdriver, remove the 2 seat track covers.
HINT:
Tape the screwdriver tip before use.
(c)
Disconnect the connectors under the seat.
(d)
Remove the 4 bolts and seat.
AVENSIS REPAIR MANUAL (RM1018E)
SEAT
–
FRONT SEAT ASSEMBLY LH (MANUAL SEAT TYPE)
2.
REMOVE VERTICAL SEAT ADJUSTER KNOB
(a)
Using a screwdriver, remove the vertical seat adjuster
knob cap and vertical seat adjuster knob.
HINT:
Tape the screwdriver tip before use.
B57834
3.
REMOVE RECLINING ADJUSTER RELEASE HANDLE
LH
(a)
Hold up the reclining adjuster release handle.
(b)
Using a screwdriver, remove the hooks and reclining ad-
juster knob cap.
HINT:
Tape the screwdriver tip before use.
B57832
(c)
Using a screwdriver, remove the hooks and reclining ad-
juster release handle.
HINT:
Tape the screwdriver tip before use.
B57833
http://vnx.su
720J8–01
Advertisement
Table of Contents
