Table of Contents
Advertisement
G21550
G21543
5.
INSTALL REAR WHEEL
Torque: 103 N m (1,050 kgf cm, 76 ft lbf)
6.
STABILIZE SUSPENSION
AVENSIS REPAIR MANUAL (RM1018E)
REAR SUSPENSION
(e)
Using SST, remove the lower control arm assy LH from
the rear axle carrier sub–assy LH.
SST
NOTICE:
Do not damage the dust cover.
SST
G23882
3.
INSPECT LOWER CONTROL ARM ASSY LH
(a)
Before installing the nut, flip the ball joint stud back and
forth 5 times as shown in the illustration.
(b)
Using a torque wrench, continuously turn the nut for 2 to
4 seconds per 1 turn, and take the torque reading at the
5th turn.
Turning torque:
3.0 N m (31 kgf cm, 27 in. lbf) or less
NOTICE:
G22395
Y
Neither unusual drag nor rattle occurs during the
rotation.
Y
Neither crack nor grease leakage exists on the dust
cover.
Y
Make sure that lower control arm assy LH is not de-
formed.
4.
INSTALL LOWER CONTROL ARM ASSY LH
(a)
Install the member side lower control arm assy LH, and
temporarily tighten bolt.
G23871
(b)
Install the nut.
Torque: 60 N m (612 kgf cm, 44 ft lbf)
(c)
Install the clip.
NOTICE:
Y
When the holes for the clip are not aligned, adjust
them by tightening the nut. The tightening angle for
the adjustment must be less than 60_.
Y
Insert the clip from the rear side of a vehicle.
G25777
(See page
27–8)
http://vnx.su
–
LOWER CONTROL ARM ASSY LH
09610–20012
27–25
Advertisement
Table of Contents
