Table of Contents
Advertisement
51–30
26.
INSPECT TIE ROD END SUB–ASSY RH
HINT:
Perform the same procedure on the other side.
27.
REMOVE STEERING RACK BOOT CLIP
(a)
Using a pliers, remove the 2 boot clips from each rack boots.
29.
REMOVE STEERING RACK BOOT NO.1 CLAMP
HINT:
Perform the same procedure on the other side.
30.
REMOVE STEERING RACK BOOT NO.2
31.
REMOVE STEERING RACK BOOT NO.1
Hold
SST(s)
SST(s)
Turn
SST(s)
AVENSIS REPAIR MANUAL (RM1018E)
POWER STEERING
–
STEERING GEAR ASSY
25.
INSPECT TIE ROD END SUB–ASSY LH
(a)
Secure the tie rod end sub–assy in a vise.
(b)
Install the nut to the stud bolt.
(c)
Flip the ball joint stud back and forth 5 times.
(d)
Using a torx wrench, turn the nut continuously at a rate of
2 to 4 seconds per turn and take the torque reading on the
5th turn.
Turning torque:
0.29 to 1.96 N m (3 to 20 kgf cm, 2.57 to 17.35 in. lbf)
ZK8184
28.
REMOVE STEERING RACK BOOT NO.2 CLAMP
(a)
Using a screwdriver, unstake the rack boot No.2 clamp.
NOTICE:
Be careful not to damage the boot.
F40083
32.
REMOVE STEERING RACK END SUB–ASSY
(a)
Using SST(s), hold the steering rack steadily and using
another SST(s), remove the rack end sub–assy.
SST
09922–10010
NOTICE:
Use SST(s) 09922–10010 in the direction shown in the il-
lustration.
HINT:
Perform the same procedure on the other side.
F40052
33.
INSPECT TOTAL PRELOAD
(a)
Temporarily install the RH and LH rack end sub–assy.
(b)
Using SST(s) and a torque wrench, check the preload.
SST
09616–00011
Preload (turning):
0.6 to 1.1 N m (6 to 11 kgf cm, 5.3 to 9.7 in. lbf)
If it is not within specification, replace the steering gear assy.
F40051
http://vnx.su
Advertisement
Table of Contents
