Toyota Avensis ZZT251 2003 Service And Repair Manual page 1477

61–18
20. INSTALL REAR SEAT ASSY
AVENSIS REPAIR MANUAL (RM1018E)
SEAT BELT – REAR SEAT BELT (SEDAN MODELS)
(1) Check that the belt does not lock within 15_ of tilt in
all directions but locks with over 45_ of tilt when
gently moving the retractor.
If operation is not as specified, replace the belt assy.
(c) Install the belt with the bolt on the floor anchor side.
Torque: 42 N m (430 kgf cm, 31 ft lbf)
NOTICE:
Make sure that the anchor part does not run onto the protru-
sion part of the floor panel.
(1) Check that the belt locks by pulling it out quickly af-
ter installation.
If operation is not as specified, replace the belt assy.
(d) Check the ELR lock.
NOTICE:
The check should be performed with the assembly
installed.
(1) Check that the belt locks by pulling it out quickly af-
ter installation.
If operation is not as specified, replace the belt assy.
(e) Check the fastening function of the child restraint system.
NOTICE:
The check should be performed with the assembly
installed.
(1) Check that the belt cannot be pulled out any more
but rewinds after being pulled out fully.
(2) Check that the belt can be pulled out and rewound
after the belt has been fully rewound.
If operation is not as specified, replace the belt assy.
(See page 72–27, 72–32)
http://vnx.su