Toyota Avensis ZZT251 2003 Service And Repair Manual page 1002

26–18
A A
A A
A
17. INSTALL FRONT SUSPENSION MEMBER BRACE REAR RH
HINT:
Install the RH side by the same procedures as the LH side.
18. CONNECT RACK & PINION POWER STEERING GEAR ASSY
(a) Electric power steering model:
(b) Oil pressure power steering model:
AVENSIS REPAIR MANUAL (RM1018E)
FRONT SUSPENSION
14.
(a)
C95318
15.
(a)
(b)
C87504
(c)
(d)
B
B
(e)
C86742
16.
(a)
(b)
B
A
A
C95317
See page 51–28
See page 51–36
http://vnx.su
– FRONT SUSPENSION ARM SUB–ASSY LOWER NO.1
LH (ATM)
TEMPORARILY TIGHTEN FRONT SUSPENSION ARM
SUB–ASSY LOWER NO.1 LH
Install the lower suspension arm sub–assy lower No.1
LH, and temporarily tighten the 2 bolts and nut.
INSTALL FRONT SUSPENSION CROSSMEMBER
SUB–ASSY
Support the front suspension crossmember sub–assy
with a transmission jack.
Install the 2 front suspension member body mounting
stoppers front and 2 nuts.
Torque: 133 N m (1,360 kgf cm, 98 ft lbf)
Connect the transverse engine engine mounting insula-
tor and engine mounting member sub–assy center to the
front suspension crossmember sub–assy.
Install the 3 bolts and 3 nuts.
Torque:
Bolt A: 52 N m (530 kgf cm, 38 ft lbf)
Bolt B: 96 N m (979 kgf cm, 71 ft lbf)
w/ HID:
Connect the height control sensor (Front) connector.
INSTALL FRONT SUSPENSION MEMBER BRACE
REAR LH
Install the front suspension member body mounting stop-
per rear to the front suspension member brace rear LH.
Install the 4 bolts and front suspension member brace
rear LH.
Torque:
Bolt A: 80 N m (816 kgf cm, 59 ft lbf)
Bolt B: 133 N m (1,360 kgf cm, 98 ft lbf)