Table of Contents
Advertisement
50–14
Matchmarks
SST
AVENSIS REPAIR MANUAL (RM1018E)
STEERING COLUMN
–
33.
REMOVE STEERING INTERMEDIATE SHAFT ASSY
NO.2 (LHD STEERING POSITION TYPE)
(a)
Place matchmarks on the steering intermediate shaft
assy No. 2 and steering main shaft.
(b)
Remove the bolt and steering intermediate shaft assy No.
2.
(c)
W/VSC:
Remove the steering sensor
F44793
34.
REMOVE STEERING COLUMN UPPER W/SWITCH
BRACKET ASSY
(a)
Using a centering punch, mark the center of the 2 ta-
pered–head bolts.
(b)
Using a 3 – 4 mm (0.12 – 0.16 in.)drill, drill into the 2 bolts.
(c)
Using a screw extractor, remove the 2 bolts and steering
Screw
column upper with switch bracket assy.
Extractor
NOTICE:
Do not give the strong force to the motor part.
F44794
35.
INSPECT STEERING COLUMN ASSY (ELECTRIC
POWER STEERING)
(a)
Using SST and a torque wrench, check the rotating
torque.
SST
Rotating torque (1 turn for 2 sec.):
0.4 – 1.1 N m (4 – 11 kgf cm, 3.5 – 9.5 in. lbf)
F44795
36.
REMOVE TRANSPONDER KEY AMPLIFIER
(a)
Widen the claw hung on the upper bracket by approx. 1.0
mm (0.039 in.) using a screwdriver.
(b)
Pull the transponder key amplifier toward the rear of the
vehicle with the claw open.
NOTICE:
Take care not to use excessive force to prevent the case
from being damaged.
F44796
37.
REMOVE IGNITION SWITCH LOCK CYLINDER ASSY
(a)
Place the ignition switch lock cylinder assy at the ACC
position.
(b)
Push down the stop pin with a screwdriver, and pull out
the cylinder assy.
F44797
http://vnx.su
STEERING COLUMN ASSY
09616–00011
(See page
32–65).
Advertisement
Table of Contents
