Table of Contents
Advertisement
AVENSIS REPAIR MANUAL (RM1018E)
HEATER & AIR CONDITIONER
20.
INSTALL MAGNET VALVE ASSY (W/ HOT GAS
HEATER)
(a)
Install the magnet valve assy with the 4 bolts.
Torque: 3.4 N m (35 kgf cm, 30 in. lbf)
I35344
21.
INSTALL REFRIGERANT FILTER (W/ HOT GAS
HEATER)
(a)
Install the refrigerant filter to the discharge tube.
I35343
22.
INSTALL DISCHARGE TUBE (W/ HOT GAS HEATER)
(a)
Install the discharge tube with the 2 bolts.
Torque: 5.4 N m (55 kgf cm, 47 in. lbf)
23.
INSTALL LIQUID TUBE SUB–ASSY B (RHD(1CD–FTV)
STEERING POSITION TYPE)
(a)
Remove the attached vinyl tape from the tube and the
connecting part of the w/ receiver condenser assy.
I35342
(b)
Sufficiently apply compressor oil to a new O–ring and the
fitting surface of the pipe joint.
Compressor oil: ND–OIL 8 or equivalent
(c)
Install the O–ring on the liquid tube sub–assy B.
(d)
Install the liquid tube sub–assy B on the w/ receiver con-
denser assy with the bolt.
Torque: 5.4 N m (55 kgf cm, 47 in. lbf)
24.
INSTALL DISCHARGE TUBE SUB–ASSY (W/ HOT
GAS HEATER)
(a)
Remove the attached vinyl tape from the tube and the
connecting part of the w/ receiver condenser assy.
(b)
Sufficiently apply compressor oil to a new 2 O–rings and
the fitting surface of the pipe joint.
I35336
Compressor oil: ND–OIL 8 or equivalent
(c)
Install the O–ring on the discharge tube sub–assy.
http://vnx.su
–
W/RECEIVER CONDENSER ASSY
55–97
Advertisement
Table of Contents
