Lower Ball Joint Assy Front Lh Replacement - Toyota Avensis ZZT251 2003 Service And Repair Manual

26–24
LOWER BALL JOINT ASSY FRONT LH
REPLACEMENT
HINT:
Y
COMPONENTS:
Y
Replace the RH side by the same procedures as the LH side.
2. REMOVE FRONT WHEEL
3. SEPARATE FRONT AXLE HUB LH NUT
SST 09930–00010
4. DISCONNECT SPEED SENSOR FRONT LH
5. SEPARATE FRONT DISC BRAKE CALIPER ASSY LH
6. REMOVE FRONT DISC
7. SEPARATE TIE ROD END SUB–ASSY LH
SST 09628–62011
8. SEPARATE FRONT SUSPENSION ARM SUB–ASSY LOWER NO.1 LH
9. REMOVE FRONT AXLE ASSY LH
SST
AVENSIS REPAIR MANUAL (RM1018E)
FRONT SUSPENSION
See page 26–2
1.
(a)
(b)
G22708
(See page
10.
(a)
(b)
F40228
11.
(a)
(b)
ZX1712
http://vnx.su
– LOWER BALL JOINT ASSY FRONT LH
INSPECT LOWER BALL JOINT ASSY FRONT LH
Jack up front side of the vehicle.
Check that there is no looseness on the ball joint by shak-
ing the lower arm up and down with a force of 294 N (30
kgf, 66 lbf).
(See page 30–6)
(See page 30–6)
(See page
(See page 30–22)
30–22)
REMOVE LOWER BALL JOINT ASSY FRONT LH
Remove the cotter pin and nut.
Using SST, remove the lower ball joint assy front LH.
INSPECT LOWER BALL JOINT ASSY FRONT LH
As shown in the illustration, flip the ball joint stud back and
forth 5 times, before installing the nut.
Using a torque wrench, turn the nut continuously at a rate
of 3 – 5 seconds per 1 turn and take the torque reading
on the 5th turn.
Turning torque:
0.98 – 4.9 N·m (10 – 50 kgf·cm, 9 – 43 in.·lbf)
30–22)
(See page 30–22)
260DS–01