Table of Contents
Advertisement
OVERHAUL
CAUTION:
Y
Wear safety gloves, because the cutting surface of the seatback frame and seat adjuster may
injure your hand.
Y
Work must be started more than 90 seconds after the ignition switch is turned to the LOCK posi-
tion and the negative (–) terminal cable is disconnected from the battery.
(The SRS is equipped with a back–up power source. If work is started within 90 seconds from
disconnecting the negative (–) terminal cable of the battery, the SRS may be deployed.)
HINT:
Y
The installation is in the reverse order of the removal. However, when there is a special point concern-
ing the installation, it is indicated.
Y
Use the same procedures on the RH side as on the LH side.
1.
REMOVE FRONT SEAT ASSY LH
(a)
Remove the headrest.
(b)
Using a screwdriver, remove the 2 seat track covers.
HINT:
Tape the screwdriver tip before use.
(c)
Disconnect the connectors under the seat.
(d)
Remove the 4 bolts and seat.
2.
REMOVE FRONT SEAT CUSHION SHIELD LH
(a)
Using a screwdriver, remove the 2 seat switch knobs.
HINT:
Tape the screwdriver tip before use.
3.
REMOVE FRONT SEAT CUSHION SHIELD INNER NO.1 LH
(a)
Remove the screw and cushion shield.
4.
REMOVE FRONT POWER SEAT SWITCH
(a)
Disconnect the connectors.
(b)
Remove the 3 screws and seat switch.
5.
REMOVE FRONT SEAT INNER BELT ASSY LH
(a)
Remove the nut and inner belt.
AVENSIS REPAIR MANUAL (RM1018E)
SEAT
(b)
Remove the 5 screws.
Claw
(c)
Using a screwdriver, disengage the claws and remove the
cushion shield with the inner No. 1 LH, and then discon-
nect the connector.
HINT:
Tape the screwdriver tip before use.
(d)
Remove the 2 screws and seat switch.
Claw
B70316
http://vnx.su
–
FRONT SEAT ASSEMBLY LH (POWER SEAT TYPE)
72–11
720J6–01
Advertisement
Table of Contents
