Table of Contents
Advertisement
RESET
1.
RESET SLIDING ROOF MOTOR
(a)
If the AUTO operation function does not operate, reset the sliding roof motor as follows:
(1)
Press the sliding roof switch on the TILT UP side and hold it until the sliding roof motor stops.
Then release the switch and leave it untouched for 10 seconds or more.
(2)
Press the sliding roof switch on the TILT UP side again for 10 seconds or more and hold it until
the sliding roof glass stops at the fully open and up position.
(3)
Release the switch, press it again within 5 seconds and hold it until a series of movements indi-
cated below have been completed:
Fully closing
HINT:
When the battery terminal is disconnected or after the jam protection function has operated, the sliding roof
motor ECU may not detect the position of the roof glass. If the AUTO operation function is still disabled even
after the sliding roof motor is reset, the Hall IC (built in the sliding roof motor) for detecting the roof glass
position may be malfunctioning.
AVENSIS REPAIR MANUAL (RM1018E)
SLIDING ROOF/CONVERTIBLE
Fully opening
Fully closing
http://vnx.su
–
SLIDING ROOF SYSTEM
74–7
7408W–01
Advertisement
Table of Contents
