Rear Axle Lh Hub Bolt Replacement - Toyota Avensis ZZT251 2003 Service And Repair Manual

30–36
DRIVE SHAFT / PROPELLER SHAFT
REAR AXLE LH HUB BOLT
REPLACEMENT
HINT:
Y
COMPONENTS:
Y
Replace the RH side by the same procedures as the LH side.
1. REMOVE REAR WHEEL
2. SEPARATE REAR DISC BRAKE CALIPER ASSY LH
(a) Removing the 2 bolts and rear disc brake caliper assy.
NOTICE:
Use a string or other device to keep the brake caliper from hanging down.
3. REMOVE REAR DISC
SST
Turn
(-C)E
Washer
Nut
Turn
(-C)F
6. INSTALL REAR DISC
7. INSTALL REAR DISC BRAKE CALIPER ASSY LH
(a) Install the rear disc brake caliper assy with the 2 bolts.
Torque: 47 N m (475 kgf cm, 34 ft lbf)
8. INSTALL REAR WHEEL
Torque: 103 N m (1,050 kgf cm, 76 ft lbf)
AVENSIS REPAIR MANUAL (RM1018E)
See page 30–30
4.
(a)
NOTICE:
Do not replace the hub bolt in any places other than that in
the illustration.
(b)
Hold
F45577
5.
(a)
(b)
Hold
F45578
http://vnx.su
– REAR AXLE LH HUB BOLT
REMOVE REAR AXLE LH HUB BOLT
Turn the axle hub to move the LH hub bolt and SST, that
are to be removed, to the place shown in the illustration.
Using SST and a hammer handle or an equivalent to hold
the axle hub, remove the LH hub bolt.
SST 09628–10011
INSTALL REAR AXLE LH HUB BOLT
Install a washer and nut to a new LH hub bolt as shown
in the illustration.
Using a hammer handle or an equivalent to hold the axle
hub, install the LH hub bolt by torquing the nut.
300K0–01