Table of Contents
Advertisement
WINDSHIELD/WINDOWGLASS/MIRROR
REPLACEMENT
HINT:
The installation is in the reverse order of the removal. However, when there is a special point concerning
the installation, it is indicated.
1.
REMOVE BACK DOOR TRIM BOARD ASSY
(a)
Remove the back door trim panel assy upper.
(b)
Remove the back door side garnish LH.
(c)
Remove the back door side garnish RH.
(d)
Remove the back door trim board.
2.
REMOVE CENTER STOP LAMP ASSY
3.
REMOVE REAR WIPER MOTOR ASSY
(a)
Remove the wiper arm head cap.
(b)
Remove the rear wiper arm.
(c)
Remove the wiper motor.
Piano Wire
Clip
Protective Tape
AVENSIS REPAIR MANUAL (RM1018E)
–
BACK DOOR GLASS (LIFTBACK MODELS)
(See page
(See page
65–26)
(See page
66–17)
4.
REMOVE BACK DOOR GLASS
(a)
Pass a piano wire between the body and glass from the
interior.
(b)
Tie both wire ends to wooden blocks or similar objects.
B68025
HINT:
Apply protective tape to the outer surface to prevent the surface
from being scratched.
NOTICE:
When separating the glass, take care not to damage the
paint and interior and exterior ornaments.
(c)
Cut off the adhesive by pulling the piano wire around the
glass.
(d)
Using a suction rubber, remove the glass.
B69235
NOTICE:
Leave as much adhesive on the body as possible when re-
moving the glass.
http://vnx.su
75–40)
70–35
700T8–01
Advertisement
Table of Contents
