Table of Contents
Advertisement
17–26
37.
INSTALL CRANKSHAFT POSITION SENSOR
Torque: 8.8 N m (90 kgf cm, 78 in. lbf)
AVENSIS REPAIR MANUAL (RM1018E)
LUBRICATION
–
OIL PUMP ASSY (1CD–FTV)
(f)
Install the oil pump with the 9 bolts.
Torque: 31 N m (320 kgf cm, 23 ft lbf)
A57099
(g)
Measure the oil pump rotating torque.
(1)
Check that the pump rotates smoothly without
noise.
(2)
Using a torque wrench, check the pump rotating
torque.
Rotating torque: 3.0 N m (31 kgf cm, 27 in. lbf) or less
A56702
38.
INSTALL OIL PAN SUB–ASSY
(a)
Remove any old packing (FIPG) and be careful not to
drop any oil on the contact surfaces of the No. 1 oil pan,
the cylinder block and the oil pump and the rear oil seal
retainer.
(1)
Using a razor blade and gasket scraper, remove all
the old packing from the gasket surfaces.
(2)
Thoroughly clean all components to remove all the
loose material.
(3)
Using a non–residue solvent, clean both the sealing
surfaces.
http://vnx.su
Advertisement
Table of Contents
