Table of Contents
Advertisement
VACUUM PUMP ASSY (1CD–FTV)
ON–VEHICLE INSPECTION
Vacuum Gauge
AVENSIS REPAIR MANUAL (RM1018E)
BRAKE
–
VACUUM PUMP ASSY (1CD–FTV)
1.
OPERATIONING CHECK
(a)
Slide the clip, then disconnect the vacuum hose from vac-
uum pump assy.
(b)
Connect the hose of the vacuum gauge to the vacuum
pump assy.
(c)
Block off another hose of the vacuum gauge with the hose
clamp No.2.
(d)
Start the engine and warm it up for more than 2 minutes.
(e)
With the engine idle, check the negative pressure of the
F45366
vacuum pump assy.
Standard: More than 650 mmHg (86.7 kPa).
(f)
Remove the vacuum gauge from the vacuum pump assy.
(g)
Connect the vacuum hose with the clip to the vacuum
pump assy.
http://vnx.su
32–33
32091–05
Advertisement
Table of Contents
