Table of Contents
Advertisement
55–98
AVENSIS REPAIR MANUAL (RM1018E)
HEATER & AIR CONDITIONER
(d)
Install the discharge tube sub–assy on the w/ receiver
condenser assy with the bolt.
Torque: 5.4 N m (55 kgf cm, 47 in. lbf)
25.
INSTALL LIQUID TUBE SUB–ASSY A
(a)
Remove the attached vinyl tape from the tube and the
connecting part of the w/ receiver condenser assy.
(b)
Sufficiently apply compressor oil to a new O–ring and the
fitting surface of the pipe joint.
Compressor oil: ND–OIL 8 or equivalent
I35337
(c)
Install the O–ring on the liquid tube sub–assy A.
(d)
w/o Hot gas heater:
Install the liquid tube sub–assy A on the w/ receiver con-
denser assy core with the bolt.
Torque: 5.4 N m (55 kgf cm, 47 in. lbf)
I35335
(e)
w/ LHD Hot gas heater:
Install the liquid tube sub–assy A on the w/ receiver con-
denser assy with the bolt.
Torque: 5.4 N m (55 kgf cm, 47 in. lbf)
26.
INSTALL COOLER REFRIGERANT DISCHARGE
HOSE NO.1
(a)
Remove the attached vinyl tape from the tube and the
connecting part of the w/ receiver condenser assy.
I35336
(b)
Sufficiently apply compressor oil to the O–ring and the fit-
ting surface of the hose joint.
Compressor oil: ND–OIL 8 or equivalent
(c)
Install the O–ring on the cooler refrigerant discharge hose
No.1.
http://vnx.su
–
W/RECEIVER CONDENSER ASSY
Advertisement
Table of Contents
