Toyota Avensis ZZT251 2003 Service And Repair Manual page 1409

SUPPLEMENTAL RESTRAINT SYSTEM
SST(s)
Stripped Wire Harness Section
AVENSIS REPAIR MANUAL (RM1018E)
HINT:
When scrapping a vehicle, deploy the airbag and scrap the ve-
hicle with the front seat airbag assy LH being installed.
2. DISPOSE OF FRONT SEAT AIRBAG ASSY LH (WHEN
DISPOSING OF AIRBAG ASSEMBLY DEPLOYMENT
METHOD)
Battery
NOTICE:
Y
When disposing of the front seat airbag assy LH only,
never use the customer's vehicle to deploy the air-
bag.
Y
Be sure to follow the procedure detailed below when
deploying the airbag.
H40005
HINT:
Prepare a battery as the power source to deploy the airbag.
(a) Check the function of the SST(s)
page
(b) Remove the front seat airbag assy LH.
(1)
(2)
CAUTION:
Y
When removing the front seat airbag assy LH, work
must be started 90 seconds after the ignition switch
is turned to the "LOCK" position and the negative (–)
terminal cable is disconnected from the battery.
Y
When storing the front seat airbag assy LH, keep the
upper surface of the airbag deployment side facing
upward.
(c) Using a service–purpose wire harness for the vehicle, tie
down the front seat airbag assy LH to the tire.
Wire Harness
Wire harness: Stripped wire harness section
Diameter
1.25 mm
HINT:
To calculate the square of the stripped wire harness section:
Square = 3.14 x (Diameter)
CAUTION:
If a wire harness which is too thin or an alternative object
H40008
is used to tie down the front seat airbag assy LH, it may be
snapped by the shock when the airbag is deployed. This is
highly dangerous. Always use a wire harness for vehicle
use which has a diameter at least 1.25 mm
http://vnx.su
– FRONT SEAT AIRBAG ASSY LH
60–19).
Remove the front seat assy LH
72–16).
Remove the 2 nuts and the front seat airbag assy
LH from the seatback assembly.
2
or more (0.0019 in
2
divided by 4
60–49
(See step 1– (a) on
(See page
2
or more)
2 2
(0.0019 in ).