Table of Contents
Advertisement
Inscribed Mark
19.
INSPECT PRESSURE PORT UNION SUB–ASSY
(a)
If the union seat in the pressure port union sub–assy is remarkably damaged, it may cause fluid leak-
age. Replace the pressure port union sub–assy.
SST(s) Oil Seal
Vinyl Tape
CE0122
AVENSIS REPAIR MANUAL (RM1018E)
POWER STEERING
If necessary, replace the flow control valve assy with the one
having the same letter as inscribed on the housing sub–assy
front
HINT:
There are 6 different marks for flow control valve assy.
D31004
18.
(a)
If it is less than the minimum, replace the compression spring.
Vernier Calipers
R08702
20.
(a)
(b)
NOTICE:
Make sure that the oil seal is installed facing in the correct
direction.
F42121
21.
(a)
(b)
NOTICE:
Do not damage the oil seal lip.
HINT:
Tape the shaft before inserting.
D30334
http://vnx.su
–
VANE PUMP ASSY (1CD–FTV)
Inscribed mark: A, B, C, D, E or F
Mark
A
B
C
D
E
F
INSPECT FLOW CONTROL VALVE COMPRESSION
SPRING
Using vernier calipers, measure the free length of the
compression spring.
Minimum free length: 36.9 mm ( 1.453 in.)
INSTALL VANE PUMP HOUSING OIL SEAL
Coat a new housing oil seal lip with power steering fluid.
Using SST(s) and a press, install a new housing oil seal.
SST
09950–60010 (09951–00280), 09950–70010
(09951–07100)
INSTALL W/PULLEY SHAFT SUB–ASSY
Coat inside bushing surface of the housing sub–assy
front with power steering fluid.
Gradually insert the w/pulley shaft sub–assy.
51–23
Part number
44330–05190
44330–05200
44330–05210
44330–05220
44330–05230
44330–05240
Advertisement
Table of Contents
