Table of Contents
Advertisement
54.
INSTALL INSTRUMENT PANEL AIR BAG ASSY
55.
INSTALL COLUMN HOLE COVER SILENCER SHEET
56.
PLACE FRONT WHEELS FACING STRAIGHT AHEAD
57.
INSTALL SPIRAL CABLE SUB–ASSY
Marks
59.
INSTALL STEERING WHEEL ASSY
(a)
Align matchmarks on the steering wheel and main shaft assembly.
(b)
Install the steering wheel set nut.
Torque: 50 N·m (510 kgf·cm, 37 ft·lbf)
(c)
Connect the connector.
Torx Screw
61.
STEERING WHEEL CENTER POINT
62.
CONNECT BATTERY NEGATIVE TERMINAL
63.
INSPECT SRS WARNING
64.
PERFORM CALIBRATION OF TORQUE SENSOR ZERO POINT (ELECTRIC POWER STEERING)
(See page
05–1045)
AVENSIS REPAIR MANUAL (RM1018E)
STEERING COLUMN
–
(See page
58.
CENTER SPIRAL CABLE
(a)
Check that the front wheels are facing straight ahead.
(b)
Turn the cable counterclockwise by hand until it becomes
harder to turn.
(c)
Then rotate the cable clockwise about 2.5 turns to align
the marks.
HINT:
The cable will rotate about 2.5 turns to either left or right of the
center.
F44800
60.
INSTALL HORN BUTTON ASSY
NOTICE:
Y
Never use airbag parts from another vehicle. When
replacing parts, replace with new ones.
Y
Make sure the horn button assy is installed with the
specified torque.
Y
If the horn button assy has been dropped, or there are
cracks, dents or other defects in the case or connec-
tor, replace the horn button assy with a new one.
Y
When installing the horn button assy, take care that
the wirings do not interfere with other parts and that
they are not pinched between other parts.
(a)
Connect the terminal.
(b)
Connect the airbag connector.
(c)
Install the steering horn button assy after confirming that
Screw Case
the circumference groove of the torx screws is caught on
the screw case.
(d)
Using a torx socket wrench, torque the 2 screws.
Torque: 8.8 N·m (90 kgf·cm, 78 in.·lbf)
F44801
LIGHT(See page
05–1184)
http://vnx.su
STEERING COLUMN ASSY
(See page
60–54)
60–26)
50–19
Advertisement
Table of Contents
