Table of Contents
Advertisement
C67583
Front
AVENSIS REPAIR MANUAL (RM1018E)
REAR SUSPENSION
(b)
Install the coil rear spring to the shock absorber assy rear
LH.
NOTICE:
Fit the lower end of the coil rear spring into the gap of the
spring lower seat.
(c)
Install the rear spring bumper No.1 LH and rear suspen-
sion support assy LH.
(d)
Set the rear coil spring insulator upper LH to the rear
spring front bracket sub–assy LH.
G24416
(e)
Position the rear spring front bracket sub–assy LH with
rear coil spring insulator upper LH as shown in the illustra-
tion.
HINT:
Place the RH side on the symmetric position to the illustration.
(f)
Install the rear suspension support assy LH and rear
shock absorber cushion washer No.1.
(g)
Temporarily tighten a new center nut.
23.7Y
(h)
Remove the SST.
C96135
(i)
Recheck the direction of the spring bracket.
(j)
Using a 6 mm hexagon wrench to hold the piston rod,
tighten a new nut.
Torque: 56 N m (571 kgf cm, 41 ft lbf)
C95738
18.
INSTALL REAR SHOCK ABSORBER WITH COIL
SPRING
(a)
Install the 3 nuts.
Torque: 80 N m (816 kgf cm, 59 ft lbf)
G23866
(b)
Install the rear shock absorber with coil spring, and tem-
porarily tighten the bolt and nut.
NOTICE:
When installing the bolt, tighten the bolt temporarily with
the nut fixed.
G23865
http://vnx.su
–
REAR SHOCK ABSORBER WITH COIL SPRING
27–11
Advertisement
Table of Contents
