Toyota Avensis ZZT251 2003 Service And Repair Manual page 1017

26–28
22. INSTALL FRONT SUSPENSION CROSSMEMBER SUB–ASSY
23. INSTALL FRONT SUSPENSION MEMBER BRACE REAR LH
24. INSTALL FRONT SUSPENSION MEMBER BRACE REAR RH
HINT:
Install the RH side by the same procedures as the LH side.
25. INSTALL RACK & PINION POWER STEERING GEAR ASSY
(a) Electric power steering model:
(b) Oil pressure power steering model:
26. INSTALL FRONT SUSPENSION ARM SUB–ASSY LOWER NO.1 LH
27. INSTALL FRONT SUSPENSION ARM SUB–ASSY LOWER NO.1 RH
HINT:
Connect the RH side by the same procedures as the LH side.
28. INSTALL TIE ROD END SUB–ASSY LH
29. INSTALL TIE ROD END SUB–ASSY RH
HINT:
Connect the RH side by the same procedures as the LH side.
31. INSTALL FRONT STABILIZER LINK ASSY RH
HINT:
Install the RH side by the same procedures as the LH side.
32. INSTALL FRONT WHEEL
Torque: 103 N m (1,050 kgf cm, 76 ft lbf)
33. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
34. HEADLIGHT AIM ONLY (W/ DISCHARGE HEAD LAMP)
AVENSIS REPAIR MANUAL (RM1018E)
FRONT SUSPENSION
21.
A
(a)
(b)
B
F45155
See page 51–28
See page 51–36
30.
(a)
HINT:
If the ball joint turns together with the nut, use a hexagon
wrench (6 mm) to hold the stud.
F44620
http://vnx.su
– STABILIZER BAR FRONT
INSTALL FRONT STABILIZER BRACKET NO.1 RH
w/ HID:
Install the front stabilizer bracket No.1 RH and the height
control sensor (Front) with the 3 bolts.
Torque:
Bolt A: 5.4 N m (55 kgf cm, 48 in. lbf)
Bolt B: 19 N m (194 kgf cm, 14 ft lbf)
w/o HID:
Install the front stabilizer bracket No.1 RH with the 2 bolts.
Torque: 19 N m (194 kgf cm, 14 ft lbf)
(See page
(See page 30–6)
INSTALL FRONT STABILIZER LINK ASSY LH
Install the front stabilizer link assy LH with the 2 nuts.
Torque: 74 N m (755 kgf cm, 55 ft lbf)
(See page
(See page
(See page 26–16)
26–16)
(See page 30–6)
26–6)
65–19)