Table of Contents
Advertisement
55–88
AVENSIS REPAIR MANUAL (RM1018E)
HEATER & AIR CONDITIONER
16.
INSTALL COOLER REFRIGERANT DISCHARGE
HOSE NO.1
(a)
Remove the attached vinyl tape from the hose.
(b)
Sufficiently apply compressor oil to a new O–ring and the
fitting surface of the w/pulley compressor assy.
Compressor oil: ND–OIL 8 or equivalent
(c)
Install the O–ring on the cooler refrigerant discharge hose
No.1.
(d)
Install the cooler refrigerant discharge hose No.1 on the
w/pulley compressor assy with the bolt.
Torque: 9.8 N m (100 kgf cm, 87 in. lbf)
17.
INSTALL COOLER REFRIGERANT SUCTION HOSE
NO.1 (RHD STEERING POSITION TYPE)
(a)
Remove the attached vinyl tape from the hose.
(b)
Sufficiently apply compressor oil to a new O–ring and the
I35332
fitting surface of the w/pulley compressor assy.
Compressor oil: ND–OIL 8 or equivalent
(c)
Install the O–ring on the cooler refrigerant suction hose
No.1.
(d)
Install the cooler refrigerant suction hose No.1 on the w/
pulley compressor assy with the bolt.
Torque: 9.8 N m (100 kgf cm, 87 in. lbf)
18.
INSTALL SUCTION SERVIC VALVE (LHD STEERING
POSITION TYPE)
(a)
Remove the attached vinyl tape from the hose.
(b)
Sufficiently apply compressor oil to a new O–ring and the
fitting surface of the w/pulley compressor assy.
Compressor oil: ND–OIL 8 or equivalent
I35330
(c)
Install the O–ring on the suction service valve.
(d)
Install the suction servic valve on the w/pulley compres-
sor assy with the 2 bolts.
Torque: 9.8 N m (100 kgf cm, 87 in. lbf)
19.
INSTALL COOLER REFRIGERANT SUCTION HOSE
NO.1 (LHD STEERING POSITION TYPE)
(a)
Remove the attached vinyl tape from the hose.
(b)
Sufficiently apply compressor oil to a new O–ring and the
fitting surface of the w/pulley compressor assy.
Compressor oil: ND–OIL 8 or equivalent
I35331
(c)
Install the O–ring on the cooler refrigerant suction hose
No.1.
http://vnx.su
–
W/PULLEY COMPRESSOR ASSY (1CD–FTV)
Advertisement
Table of Contents
