Toyota Avensis ZZT251 2003 Service And Repair Manual page 1057

30–26
DRIVE SHAFT / PROPELLER SHAFT
19. INSTALL LOWER BALL JOINT ASSY FRONT LH
(a) Install the lower ball joint and torque the nut.
Torque: 103 N m (1,050 kgf cm, 76 ft lbf)
(b) Install a new cotter pin.
NOTICE:
If the holes for the cotter pin are not aligned, tighten the nut up to 60_ further.
22. INSTALL TIE ROD END SUB–ASSY LH
(a) Install the tie rod end sub–assy LH to the steering knuckle.
(b) Install the nut and a new cotter pin.
Torque: 49 N m (500 kgf cm, 36 ft lbf)
NOTICE:
If the holes for the cotter pin are not aligned, tighten the nut up to 60_ further.
23. INSTALL FRONT STABILIZER LINK ASSY LH
24. INSTALL FRONT DISC
AVENSIS REPAIR MANUAL (RM1018E)
– FRONT AXLE HUB SUB–ASSY LH
20. INSTALL FRONT AXLE ASSY LH
(a) Install the 2 bolts, nuts and steering knuckle with 2 bolts
and nuts to the shock absorber.
Torque: 220 N m (2,243 kgf cm, 162 ft lbf)
NOTICE:
Only when reusing the bolts and nuts, apply engine oil to
the screw part of the nuts.
(b) Push the front axle assy toward the outside of the vehicle,
fit the splined part of the drive shaft assy to that of the front
C83023
axle assy and insert the drive shaft assy into the front axle
assy.
NOTICE:
Y
Do not push out the front axle assy excessively.
Y
Be careful not to damage the drive shaft outboard
joint boot.
Y
Be careful not to damage the speed sensor rotor.
21. INSTALL FRONT SUSPENSION ARM SUB–ASSY
LOWER NO.1 LH
(a) Install the front suspension arm sub–assy lower No.1 LH
and lower ball joint with the 2 nuts and bolt.
Torque: 89 N m (908 kgf cm, 66 ft lbf)
C80293
(See page
http://vnx.su
30–6)