Toyota Avensis ZZT251 2003 Service And Repair Manual page 1496

65–20
V RH Line
90_
3 m (9.84 ft)
V LH Line
V LH Line
Low Beam:
V RH Line
6mm
(0.23 in.)
H Line
30mm
(1.18 in.)
V LH Line
High Beam:
V RH Line
H Line
Adjusting Bolt A
AVENSIS REPAIR MANUAL (RM1018E)
LIGHTING
(c)
V Line
I35248
NOTICE:
Y
Y
84 mm
(3.3 in.)
HINT:
I37308
When checking the aiming of the High–beam, shut off the Low–
beam or disconnect the Low–beam headlight connector.
I37102
(d)
Adjusting Bolt B
NOTICE:
Y
Y
HINT:
I35802
The optical axis aim moves downward when turning the screw-
driver clockwise, and it moves upward when turning the screw-
driver counterclockwise.
(e)
NOTICE:
Y
Y
http://vnx.su
– HEADLAMP UNIT LH
Check the headlight aiming.
(1) Align the paper with the center of the vehicle.
Y
Make a distance of 3 m ( 9.84 ft) between the head-
lights and the paper, and put the paper against a
wall with the H line being at the same height as the
center mark.
Y
Align the center of the vehicle with the V line on the
paper, and ensure that the paper is at a 90_ angle
in accordance to the V line.
(2) Start the engine.
(3) Turn on the headlights and check that the aim is with
in the specified valves shown in the illustration.
When covering the headlights, finish it within 3 mi-
nuites.
The headlight lens is made of synthetic resin, so it is
easily.
Adjust the aim in the vertical direction:
Using a screwdriver, adjust the headlight aim within the
specified range by turning the aiming screw A.
Adjust the headlight aim by turning the screw in the
tightening direction.
When the screw is tightened excessively, loosen it
once and re–tighten it to adjust the headlight aim.
Adjust the aim in the horizontal direction:
Using a screwdriver, adjust the headlight aim within the
specified range by turning the aiming screw B.
Adjust the headlight aim by turning the screw in the
tightening direction.
When the screw is tightened excessively, loosen it
once and re–tighten it to adjust the headlight aim.