Table of Contents
Advertisement
16–32
2.
ADD ENGINE COOLANT
(a)
Tighten the radiator drain plug, and pour coolant into radiator until it overflows.
Capacity:
Transmission type
M/T
M/T
A/T
A/T
NOTICE:
Y
Do not use an alcohol type coolant or plain water alone.
Y
The coolant should be mixed with plain water (preferably demineralized water or distilled wa-
ter).
HINT:
Y
Use of improper coolants may damage engine cooling system.
Y
Use "Toyota Long Life Coolant" or equivalent and mix it with plain water according to the manufactur-
er's directions.
Y
Using of coolant with includes more than 50 % (freezing protection down to –35_C (–31_F)) or 60 %
(freezing protection down to –50_C (–58_F)) of ethylene–glycol is recommended but not more than
70 %.
Y
Press the radiator inlet and outlet hose several times with hard.
Y
If the coolant level gets lower, pour coolant.
(b)
Reinstall the radiator cap.
(c)
Pour engine coolant into the reservoir tank until it reaches full line.
(d)
Warm up the engine until the thermostat valve begins to open.
HINT:
Press the radiator inlet and outlet hose several times with hard during the warming up.
(e)
Stop the engine and wait until the coolant temp. Gets cold. Then remove the radiator cap to check the
coolant level.
HINT:
Y
If the level gets lower, perform the procedures above again.
Y
If the level does not gets lower, adjust the reservoir tank coolant level.
3.
CHECK FOR ENGINE COOLANT LEAKS
AVENSIS REPAIR MANUAL (RM1018E)
COOLING
–
ENGINE COOLANT (1AZ–FSE)
Steering
LHD
RHD
LHD
RHD
(See page
16–25)
http://vnx.su
Coolant Capacity
[liters (US gts, lmp. gts)]
6.0 (6.3, 5.3)
6.1 (6.4, 5.4)
6.3 (6.7, 5.5)
6.4 (6.8, 5.6)
Advertisement
Table of Contents
