Crankshaft Position Sensor (1Zz–Fe/3Zz–Fe) Replacement - Toyota Avensis ZZT251 2003 Service And Repair Manual

18–6
CRANKSHAFT POSITION SENSOR (1ZZ–FE/3ZZ–FE)
REPLACEMENT
1. REMOVE ENGINE UNDER COVER LH
2. REMOVE ENGINE UNDER COVER SUB–ASSY NO.1
3. REMOVE ENGINE UNDER COVER RH
4. REMOVE RADIATOR SUPPORT OPENING COVER
5. REMOVE ENGINE ROOM COVER SIDE
6. REMOVE FAN AND GENERATOR V BELT
7. REMOVE GENERATOR ASSY
(b)
(a)
(e)
(f)
10. INSTALL GENERATOR ASSY
11. INSTALL FAN AND GENERATOR V BELT
12. INSTALL ENGINE ROOM COVER SIDE
13. INSTALL RADIATOR SUPPORT OPENING COVER
14. INSTALL ENGINE UNDER COVER RH
15. INSTALL ENGINE UNDER COVER SUB–ASSY NO.1
16. INSTALL ENGINE UNDER COVER LH
AVENSIS REPAIR MANUAL (RM1018E)
IGNITION
(See page
8.
(a)
(b)
(c)
(d)
A78483
9.
(d)
(a)
(b)
(c)
(d)
(e)
(f)
A78484
(See page
http://vnx.su
– CRANKSHAFT POSITION SENSOR (1ZZ–FE/3ZZ–FE)
(See page 19–20)
(See page
(See page 19–20)
(See page
(See page 10–9)
(See page 14–5)
19–7)
REMOVE CRANKSHAFT POSITION SENSOR
Disconnect the crankshaft position sensor connector.
Remove the connector clamp.
Remove the 2 bolts, and then remove the crankshaft posi-
tion sensor.
Remove the cord clamp from the crankshaft position sen-
sor.
INSTALL CRANKSHAFT POSITION SENSOR
Install the cord clamp to the crankshaft position sensor.
Apply a light coat of engine oil on the O–ring of the crank-
shaft position sensor.
Install the crankshaft position sensor with the 2 bolts.
Torque: 9.0 N m (92 kgf cm, 80 in. lbf)
Install the wire harness as shown in the illustration.
Install the connector clamp.
Connect the crankshaft position sensor connector.
19–7)
(See page 14–5)
10–17)
10–9)
1807J–01