Suzuki GA413 Service Manual page 1101

1. Engine rear mounting (For truck)
2. Engine rear mounting (For van)
REMOUNTING
For remounting, reverse dismounting procedure.
Use specified torques as given below.
Tightening Torque
.
(a): 55 N m (5.5 kg-m, 40.0 Ib-ft)
.
(b): 25 N m (2.5 kg-m, 18.0 Ib-ft)
NOTE:
D To facilitate remounting, install rear mounting to transmis-
sion after inserting input shaft into clutch disc.
D For tightening torque of starting motor bolts, refer to Section
6G.
D Refill specified amount of gear oil as previously outlined.
D After connecting clutch cable, be sure to adjust its play prop-
erly (refer to "CLUTCH" section).
D Press-fit engine rear mounting bush to bracket as shown in
figure, if removed.
D Install propeller shafts referring to "PROPELLER SHAFT"
section.
MANUAL TRANSMISSION (4WD) 7A1-7