Wheel Cylinder; Brake Back Plate - Suzuki GRAND VITARA XL-7 Owner's Manual

Wheel Cylinder

INSTALLATION
For the details, refer to the same item of the same section in the
service manual mentioned in the FOREWORD of this manual not-
ing the following points.
• Take off bleeder plug cap from brake pipe and connect pipe
(or pipes) to wheel cylinder (1) just enough to prevent fluid
from leaking.
• Tighten wheel cylinder to brake back plate (1) to specified
torque.
Tightening torque
Wheel cylinder bolt (for non sealed type) (a):
13.5 N·m (1.35 kg-m, 10.0 lb-ft)
Brake pipe flare nut (b):
16 N·m (1.6 kg-m, 12.0 lb-ft)

Brake Back Plate

INSTALLATION
1) Install brake back plate (3) to rear axle shaft (1).
2. Wheel beaning
2) Apply sealant "A" to joint seam of rear axle housing (1) and
brake back plate.
"A" : Sealant 99000-31110
NOTE:
Make sure to remove old sealant before applying it anew.
3) Install rear axle shaft to rear axle housing.
PARKING AND REAR BRAKE 5C-5