Suzuki GA413 Service Manual page 33

0B-8 MAINTENANCE AND LUBRICATION
Proper Engine Oil Viscosity Chart
Temperature
Engine oil capacity
Oil pan capacity
(8.5/ 7.0 US / Imp pt.)
Oil filter capacity
(0.4 / 0.35 US / Imp pt.)
Others
(1.7 / 1.4 US / Imp pt.)
Total
(10.6 / 8.8 US / Imp pt.)
1. Oil filter
About 4.0 liters
About 0.2 liters
About 0.8 liters
About 5.0 liters
1. Full level mark (hole)
2. Low level mark (hole)
5) Tighten filter 3/4 turn from the point of contact with the mounting
surface using an oil filter wrench.
Special Tool
(A): 09915-40611
Tightening Torque
.
(b): 14 N m (1.4 kg-m, 10.5 lb-ft)
6) Replenish oil until oil level is brought to FULL level mark on dip-
stick. (oil pan and oil filter capacity). The filler inlet is at the top
of the cylinder head cover.
It is recommended to use engine oil of SE, SF, SG, SH or SJ
grade.
NOTE:
For temperature between –20_C (–4_F) and 30_C (86_F), it
is highly recommended to use SAE 10W – 30 oil.
NOTE:
Engine oil capacity is specified. However, note that the
amount of oil required when actually changing oil may
somewhat differ from the data in the table depending on
various conditions (temperature, viscosity, etc.)
7) Check oil filter and drain plug for oil leakage.
8) Start engine and run it for three minutes. Stop it and wait five
minutes before checking oil level. Add oil, as necessary, to bring
oil level to FULL level mark on dipstick.
NOTE:
Step 1) – 7) outlined above must be performed with ENGINE
NOT RUNNING. For step 8), be sure to have adequate ven-
tilation while engine is running.