Brake Back Plate - Suzuki Jimny Service Manual

5-34 BRAKES
INSTALLATION
1) Apply sealant to wheel cylinder. Then take off bleeder plug
cap from brake pipe and connect pipe (for pipes) (3) to wheel
cylinder just enough to prevent fluid from leaking.
"A" : Sealant 99000-31090
2) Tighten wheel cylinder to brake back plate (1) to specified
torque.
3) Torque flare nut (or nuts) (2) of brake pipe which was con-
nected in step 1) to specification.
Tightening torque
Wheel cylinder mounting bolts
(a) : 9 N·m (0.9 kg-m, 6.5 lb-ft)
Brake pipe flare nut
(b) : 16 N·m (1.6 kg-m, 11.5 lb-ft)
4. Wheel cylinder bolts
4) Install breather plug cap taken off from pipe back to breather
plug.
5) For procedure hereafter, refer to "Brake Shoe" in this sec-
tion.
NOTE:
Be sure to bleed brake system.

Brake back plate

REMOVAL
1) Remove brake drum referring to "Brake Drum" in this sec-
tion.
2) Remove brake shoe referring to "Brake Shoe" in this section.
3) Remove wheel cylinder referring to "Wheel Cylinder" in this
section.
4) Drain rear differential gear oil.
5) Remove cable from brake back plate (2) by squeezing park-
ing brake cable stopper ring (1).
6) Remove brake back plate nuts (3) from rear axle housing.