Brake Back Plate (For 2Wd Vehicle) - Suzuki Ignis Service Manual

INSTALLATION
1) Take off bleeder plug cap from brake pipe and connect pipe
to wheel cylinder (1) just enough to prevent fluid from leak-
ing.
2) Install wheel cylinder (1) to brake back plate (2) to specified
torque.
Tightening torque
Cylinder mounting bolts (a) : 10 N·m (1.0 kg-m, 7.5 lb-ft)
3) Tighten flare nut (3) of brake pipe to specified torque.
Tightening torque
Rear brake pipe flare nut (b) : 16 N·m (1.6 kg-m, 11.5 lb-ft)
4) Install bleeder plug cap.
5) Install brake shoes. (Refer to "BRAKE SHOE".)
6) Install brake drum. (Refer to "BRAKE DRUM".)
7) Fill reservoir with brake fluid and bleed brake system. (For
bleeding operation referring to "AIR BLEEDING OF BRAKE
SYSTEM".)
8) Upon completion of all jobs, depress brake pedal with about
30 kg (66 lbs) load 3 to 5 times so as to obtain proper drum-
to-shoe clearance.
Adjust parking brake cable.
9) Install wheel and tighten wheel nuts to specified torque.
Tightening torque
Wheel nuts : 85 N·m (8.5 kg-m, 61.5 lb-ft)
10) Check to ensure that brake drum is free from dragging and
proper braking is obtained. Then remove vehicle from hoist
and perform brake test (foot brake and parking brake).
11) Check each installed part for oil leakage.

BRAKE BACK PLATE (FOR 2WD VEHICLE)

REMOVAL
1) Remove brake drum referring to "BRAKE DRUM".
2) Remove brake shoe referring to "BRAKE SHOE".
3) Remove wheel cylinder referring to "WHEEL CYLINDER".
4) Remove parking brake cable securing clip (1) and discon-
nect brake cable (2) from brake back plate (3).
BRAKES 5-31