Thermo Scientific Dionex UltiMate 3000 Series Operating Instructions Manual page 244

UltiMate 3000 Series:
NCS-3500RS and NCP-3200RS
Pump Module*
Wetted parts:
* Typical operating conditions for measurable specifications:
NC pump: Nominal flow of the flow meter (see Pressure range above) @ 20 MPa
Loading pump: 200 or 300 µL/min @ 17 MPa or 25 MPa
Column Compartment
Temperature range:
Temperature accuracy:
Temperature stability:
Temperature precision:
Column capacity:
Warm up time:
Column switching valves:
Wetted parts:
Safety features:
General Module Information
User input/display:
GLP features:
Page 236
NC pump
Titanium, PEEK, UHMW
polyethylene, PTFE, FEP, sapphire,
zirconium oxide, aluminum oxide,
fused silica, MP35N
In addition for ProFlow flow meter
only: PCTFE, stainless steel
Ambient +7 °C to 75 °C
±0.5 °C (measured at 50 °C setpoint)
±0.1 °C (measured at 50 °C setpoint)
±0.1 °C
Maximum available width for column plus fittings: 350 mm; coiled
columns
from 35 °C to 65 °C in 12 minutes (typically)
at an ambient temperature of 25 °C
Up to two
2-position, 10-port or 2-position, 6-port switching valves
Port-to-port volume:
10-port valve:114 nL
6-port valve: 91 nL
Column switching valves: Nitronic
Humidity sensor, gas sensor
Standby button
Separately for pump module and column compartment:
LCD indicating system parameters
3 LEDs (Power, Connected, and Status) for status monitoring
4 function keys for operation during initial installation and maintenance
In Chromeleon:
• Electronic identification system for 4 columns
• System Wellness monitoring
• All system parameters are recorded in the Audit Trail.
Loading pump
Titanium, PEEK, UHMW
polyethylene, PTFE, FEP, ruby,
zirconium oxide, aluminum oxide,
perfluoro elastomer (FFKM)
®
60, Valcon E3
Operating Instructions