Thermo Scientific Dionex UltiMate 3000 Series Operating Instructions Manual page 111

To ...
Loading pump only
See the workload of the related pump head since the pump has been
operated for the first time. The workload is calculated from the flow rate,
pressure, and time.
See which firmware version is installed in the module.
See the bootloader version.
See the serial number of the module:
5.4.2.2.5 Configuration Menu
The Configuration menu provides information about the configuration of the pump module
and allows you to make the required settings or perform the related commands.
To ...
Set the display and function key parameters:
Brightness—sets the screen brightness. (The input is in percent.)
Contrast—sets the screen contrast. (The input is in percent.)
Key sound—sets whether a beep sounds when you select a function key.
Key autorepeat—sets whether the keystroke is automatically repeated when
you remain on the key for a longer period, for example, to change a value
quickly.
Turn leak detection off if necessary and on again:
Disabled—turns leak detection off.
Enabled—turns leak detection on.
Leak detection is enabled as a standard. For more information about how
operate the pump with leak detection, see page 124.
Set the pressure unit.
Restore the factory settings for the pump module. In the Reset to factory
defaults? dialog box, select OK to confirm the restore the factory settings or
select Cancel to keep your settings.
Tip: The command restores the factory settings for all pumps of the pump
module, independent of whether you perform the command from the NC pump
menu or loading pump menu.
Operating Instructions
UltiMate 3000 Series:
NCS-3500RS and NCP-3200RS
Select ...
Workload
Firmware Version
Bootloader Version
Serial Number
Select ...
Display & Soft Keys
Leak Sensor Mode
Pressure Unit
Reset to Factory
Defaults
Page 103