UltiMate 3000 Series:
NCS-3500RS and NCP-3200RS
4.2.2 Routing Capillaries
When routing capillaries in the module or to other system modules, observe the following
general information:
Pump Module
•
Two passages in the enclosure bottom of the pump module (→ Fig. 4, page 27) facilitate
routing the capillaries to the modules that are located below the pump module and ensure
the shortest possible connection.
•
Two clips are installed in the pump module, for example, to secure the solvent lines to
the interior front panel of the pump.
Column Compartment
Capillaries to be routed to the outside on the sides of the column chamber have to be
•
routed through the guides provided on the left and right of the column chamber.
Fig. 22: Capillary guides (here on the right of the column chamber)
•
Capillaries to be routed to the outside on the top or bottom of the column chamber can be
routed out of the interior at any position between the top or bottom of the enclosure and
the front panel door to make sure that the connections are as short as possible.
Page 60
Fig. 21: Clips in the pump module
Preinstalled clips
Operating Instructions