Fluid Connections - Thermo Scientific Dionex UltiMate 3000 Series Operating Instructions Manual

2.7 Fluid Connections

The fluid components are located behind the front panel doors of the pump module and
column compartment. The module is designed to provide easy access to the fluid
components.
Pump Module
Tilt the front cover of the pump module upward. The open front panel locks in the topmost
position. Observe the information under Important further down in this section.
Two passages in the enclosure bottom of the pump module facilitate routing the capillaries to
the modules that are located below the pump module, for example, the column compartment,
and ensure the shortest possible connection.
Column Compartment
Unlock the front panel door as shown in the picture. The door tilts downward. To close the
column chamber, tilt the front panel upward. The door locks automatically.
Important:
Important:
Operating Instructions
Fig. 4: Capillary passage in the pump module
Fig. 5: Unlocking the front panel door
The open front panel doors of the pump and column compartment
are not designed to carry weight. Therefore, you should not place
any objects on the open doors.
When lifting or moving the module, always lift by the bottom or
sides of the module. Do not lift the module by the front panel door.
This may damage the door.
Ne placez aucun objet lourd sur les portes ouvertes des panneaux
avant. Ceci peut endommager les portes.
Lorsque vous soulevez ou déplacez l'instrument, saisissez-la toujours
par les côtés de l'instrument. Soulever l'instrument par le panneau
avant risque d'endommager les portes des panneaux avant.
UltiMate 3000 Series:
NCS-3500RS and NCP-3200RS
Capillary passage
in the pump module
Page 27