Automated Control - Thermo Scientific Dionex UltiMate 3000 Series Operating Instructions Manual

UltiMate 3000 Series:
NCS-3500RS and NCP-3200RS

5.3.3 Automated Control

With automated control, you create a program file (PGM) for automated operation of the
module. You can create programs automatically with the software wizard or manually by
editing an existing program. In addition to programs for sample analysis, you can also
create programs for special purposes, for example, to automate system shutdown
(→ page 141) or to ensure that the system automatically restarts operation as desired after a
power failure. For details, see the Chromeleon Help.
To create a program with the Program Wizard
1. Open the Program Wizard. On the File menu, select New, and then select Program
File.
2. The wizard guides you through program creation. On each wizard page, accept or
change the settings as appropriate. For additional information about a page, click
Help.
3. After you finish the wizard, Chromeleon automatically creates the corresponding
program.
4. To start the program, follow the steps below (→ page 93).
To create a program manually
1. Open an existing program.
Select and double-click the program you want to open.
—or—
On the File menu, select Open. In the dialog box, select Program on the Object of Type
list and select the program.
Opens the
Commands View
Open the
Device Views
Fig. 47: Chromeleon program (here program shown in the Commands view)
Page 92 Operating Instructions