Thermo Scientific Dionex UltiMate 3000 Series Operating Instructions Manual page 114

UltiMate 3000 Series:
NCS-3500RS and NCP-3200RS
5.4.2.3.4 Configuration Menu
The Configuration menu provides information about the configuration of the column
compartment and allows you to make the required settings or change the settings.
To ...
Set the display and function key parameters:
Brightness—sets the screen brightness. (The input is in percent.)
Contrast—sets the screen contrast. (The input is in percent.)
Key sound—sets whether a beep sounds when you select a function key.
Key autorepeat—sets whether the keystroke is automatically repeated when
you remain on the key for a longer period, for example, to change a value
quickly.
Specify which valve is installed in the left and/or right position.
Determine whether leak detection is performed and how you are alerted in
case of an alarm. Select the sensor and set the sensitivity:
Low, Standard, or High—turns leak detection on and sets the sensitivity
with which the sensors respond to excessive gas or humidity. When a sensor
is activated, a message appears on the pump display and a beep alerts you
(when set under Leak Alarm Mode).
Off—turns leak detection off.
Determine whether a beep alerts you when the gas and/or humidity sensor is
activated, in addition to the message on the pump display (audible = yes,
silent = no).
Move the actuator for the column switching valve into the correct position for
valve installation if necessary. For details, see section 4.6.1 (→ page 78).
To restore the factory settings for the column compartment. In the Reset to
factory defaults? dialog box, select OK to confirm the restore the factory
settings or select Cancel to keep your settings.
Page 106
Select ...
Display & Soft Keys
Left Valve Config
Right Valve Config
Gas Leak Mode
Humidity Leak Mode
Leak Alarm Mode
Catch Left Valve Head
Catch Right Valve Head
Reset to Factory
Defaults
Operating Instructions