Connecting The Module; General Information; Connecting The Usb Cable - Thermo Scientific Dionex UltiMate 3000 Series Operating Instructions Manual

3.4 Connecting the Module

3.4.1 General Information

If you want to operate the module from Chromeleon
Before you connect the module to the USB port on the Chromeleon computer and turn on the
module power, verify that Chromeleon is installed on the computer and that the license code
is entered. Only if you install Chromeleon first, the USB driver for the module is
automatically loaded and the Windows
power is turned on.

3.4.2 Connecting the USB Cable

Connect the module to the Chromeleon computer by using the USB ports on the rear panel
(→ Fig. 2, page 24). Select one of the following alternatives:
• Connect the module directly to the USB port on the Chromeleon computer.
• Connect the module to the computer by using an external USB hub. (However, this may
be the source for communication problems, depending on the quality of the hub.)
Tip:
The USB standard limits the USB cable length to 5 meters. Each USB device
can be separated from the PC or next USB hub by no more than 5 meters
To ensure trouble-free operation, use only these cables for the connection (both cables are
provided in the accessories kit for the module):
USB Cable
USB cable, type A to type B, high speed USB 2.0
(cable length: 5 m)
USB cable, type A to type B, high speed USB 2.0
(cable length: 1 m)
Operating Instructions
®
operating system can detect the module when the
UltiMate 3000 Series:
NCS-3500RS and NCP-3200RS
Part No.
6911.0002
6035.9035
Page 41