Installation; Facility Requirements; Unpacking - Thermo Scientific Dionex UltiMate 3000 Series Operating Instructions Manual

3 Installation

3.1 Facility Requirements

The installation site must meet the following requirements:
• The main power switch and the main power receptacle are on the rear panel. Make sure
that
♦ Free and unrestricted access to the main power switch is ensured at all times.
♦ The power cord of the device can be easily reached and disconnected from the
power line at all times. Provide sufficient space behind the device to unplug the
cable.
• Make sure that the installation site meets the power and environmental specifications
listed in the Technical Information section (→ page 235).
• Install the module in the laboratory on a stable surface. Make sure that the position is
horizontal and free of vibrations.
• Make sure that the surface is resistant to solvents.
• Avoid locations with extreme changes in temperature.
• Also, avoid locations with extreme direct sunlight and high humidity.
• Allow sufficient clearance behind and to the sides of the module for ventilation and do
not place any objects between the module and the module located below it in the system
stack

3.2 Unpacking

All electrical and mechanical components of the module are carefully tested before the
module is shipped from the factory. After unpacking, inspect the module for any signs of
mechanical damage that may have occurred during transit.
Tips: Immediately report any shipping damage to both, the incoming carrier and
Thermo Fisher Scientific. Shipping insurance will compensate for the damage
only if reported immediately.
Keep the original shipping container and packing material. They will provide
excellent protection for the module in case of future transit. Shipping the
module in any other packaging automatically voids the product warranty.
Operating Instructions
UltiMate 3000 Series:
NCS-3500RS and NCP-3200RS
Page 37