Thermo Scientific Dionex UltiMate 3000 Series Operating Instructions Manual page 46

UltiMate 3000 Series:
NCS-3500RS and NCP-3200RS
1. Only NCS-3500RS
Place the shipping container on the floor, remove the container cover, and take out the
spacer box. The NCS packaging box may remain in the bottom part of the shipping
container.
2. Open the packaging box of the module, and remove the accessories kit and power
cord. Some accessories may be shipped in a separate box.
3. Grasp the module by the sides. Slowly and carefully, pull the module out of the
shipping container and place it on a stable surface.
Important: To prevent the module from falling, grasp the module by the sides,
Important: Afin d'empêcher l'instrument de tomber, saisissez-la par les côtés.
4. Remove the foam spacers, and then remove the polythene packaging.
5. Tilt the front panel of the pump module upward and remove the foam inserts securing
the front panel door during shipment.
6. Only NCS-3500RS
Unlock the front panel door of the column compartment (→ page 27) and remove the two
foam inserts securing the valve drives during shipment.
7. Before connecting the module to the power source, wait approximately four hours to
allow the instrument to come to room temperature and to allow any condensation that
might have occurred during shipping to evaporate.
After four hours, check the module; if condensation still exists, allow the module to
continue to warm up (without connecting it to the power source) until the condensation is
completely gone.
Page 38
and then lift the module together with the foam spacers out of the
shipping container. Do not lift the module by the foam spacers and
not by the front panel doors.
A team effort is required to lift or move the NCS-3500RS. The
NCS-3500RS is too heavy and/or bulky for one person alone to lift
or move safely.
Ne soulevez l'instrumente à l'aide du matériau d'emballage ou par
les portes des panneaux avants.
Le NCS-3500RS et lourd et encombrant. Par conséquent, vous ne
devriez pas soulever l'instrument seul.
Operating Instructions