2.5.1 Power Switch
The main power switch is on the rear panel. The main power switch is used to turn the
device on or off.
2.5.2 Fuse Cartridge
The fuse cartridge contains two slow-blow fuses rated at 2 A (NCP-3200RS) or 4 A (NCS-
3500RS). For information about how to change the fuses, see page 216.
2.5.3 USB Port
The Chromeleon Chromatography Management System can use a USB (= Universal Serial
Bus) connection to control the module. Data is transferred digitally by means of the
appropriate USB cable (→ page 41).
You can use the internal USB hub (→ Fig. 2, no. 10) to connect three other modules in the
UltiMate 3000 product line, depending on the configuration of the UltiMate 3000 system, or
three external USB hubs.
Important: Thermo Fisher Scientific recommends using these USB ports only for
connections to Dionex instruments. Thermo Fisher Scientific cannot
guarantee correct functioning if third-party instruments are connected.
Important: Thermo Fisher Scientific recommande d'utiliser les ports USB
uniquement pour les raccordements aux instruments Dionex. Thermo
Fisher Scientific ne peut garantir le bon fonctionnement si les
instruments d'autres fabricants sont raccordés.
For information about how to connect the module to the Chromeleon computer, see
sections 3.4.1 and 3.4.2 (→ page 41).
2.5.4 Digital I/O
The digital I/O ports on the module provide two inputs and two relay outputs that can be
used to exchange digital signals with external devices. For more information, see page 42.
For information about the functions of the connector pins and pin assignment, see page 255.
2.5.5 Solvent Rack
Use this port to connect a SRD-3x00 Solvent Rack with integrated vacuum degasser
(→ page 20) to the module.
For information about the pin assignment of the Solvent Rack port, see page 256. For
information about how to install and operate the Solvent Rack, see the Solvent Rack manual.
Operating Instructions
UltiMate 3000 Series:
NCS-3500RS and NCP-3200RS
Page 25