NEC 78K0 Series User Manual page 324

(8) Interrupt request flag (ADIF)
The interrupt request flag (ADIF) is not cleared even if the analog input channel specification register (ADS) is
changed.
Therefore, if an analog input pin is changed during A/D conversion, the A/D conversion result and ADIF for the
pre-change analog input may be set just before the ADS rewrite. Caution is therefore required since, at this time,
when ADIF is read immediately after the ADS rewrite, ADIF is set despite the fact A/D conversion for the post-
change analog input has not ended.
When A/D conversion is stopped and then resumed, clear ADIF before the A/D conversion operation is resumed.
Figure 13-21. Timing of A/D Conversion End Interrupt Request Generation
ADS rewrite
(start of ANIn conversion)
A/D conversion
ADCR
ADIF
Remarks 1. n = 0 to 7
2. m = 0 to 7
(9) Conversion results just after A/D conversion start
The first A/D conversion value immediately after A/D conversion starts may not fall within the rating range if the
ADCS bit is set to 1 within 1
0. Take measures such as polling the A/D conversion end interrupt request (INTAD) and removing the first
conversion result.
(10) A/D conversion result register (ADCR, ADCRH) read operation
When a write operation is performed to the A/D converter mode register (ADM), analog input channel
specification register (ADS), and A/D port configuration register (ADPC), the contents of ADCR and ADCRH may
become undefined. Read the conversion result following conversion completion before writing to ADM, ADS, and
ADPC. Using a timing other than the above may cause an incorrect conversion result to be read.
324
CHAPTER 13 A/D CONVERTER
ADS rewrite
(start of ANIm conversion)
ANIn ANIn
ANIn
µ
s after the ADCE bit was set to 1, or if the ADCS bit is set to 1 with the ADCE bit =
Preliminary User's Manual U17260EJ3V1UD
ADIF is set but ANIm conversion
has not ended.
ANIm ANIm
ANIn ANIm ANIm