Operation Of Serial Interface Uart6; Operation Stop Mode - NEC 78K0 Series User Manual

15.4 Operation of Serial Interface UART6

Serial interface UART6 has the following two modes.

• Operation stop mode

• Asynchronous serial interface (UART) mode
15.4.1 Operation stop mode
In this mode, serial communication cannot be executed; therefore, the power consumption can be reduced. In
addition, the pins can be used as ordinary port pins in this mode. To set the operation stop mode, clear bits 7, 6, and
5 (POWER6, TXE6, and RXE6) of ASIM6 to 0.
(1) Register used
The operation stop mode is set by asynchronous serial interface operation mode register 6 (ASIM6).
ASIM6 can be set by a 1-bit or 8-bit memory manipulation instruction.
Reset signal generation sets this register to 01H.
Address: FF50H After reset: 01H R/W
Symbol <7>
ASIM6 POWER6
POWER6
Note 1
0
TXE6
0
RXE6
0
Notes 1. The output of the T
POWER6 = 0 during transmission.
2. Asynchronous serial interface reception error status register 6 (ASIS6), asynchronous serial interface
transmission status register 6 (ASIF6), bit 7 (SBRF6) and bit 6 (SBRT6) of asynchronous serial
interface control register 6 (ASICL6), and receive buffer register 6 (RXB6) are reset.
Caution Clear POWER6 to 0 after clearing TXE6 and RXE6 to 0 to stop the operation.
To start the communication, set POWER6 to 1, and then set TXE6 or RXE6 to 1.
Remark To use the R
FUNCTIONS.
CHAPTER 15 SERIAL INTERFACE UART6
<6> <5>
TXE6 RXE6
Enables/disables operation of internal operation clock
Disables operation of the internal operation clock (fixes the clock to low level) and asynchronously
Note 2
resets the internal circuit .
Disables transmission operation (synchronously resets the transmission circuit).
Disables reception (synchronously resets the reception circuit).
D6 pin goes high and the input from the R
X
D6/P14 and T D6/P13 pins as general-purpose port pins, see CHAPTER 5
X X
Preliminary User's Manual U17260EJ3V1UD
4 3
PS61 PS60 CL6
Enables/disables transmission
Enables/disables reception
X
2 1
SL6 ISRM6
D6 pin is fixed to high level when
0
PORT
363