Engine Model And Serial Number Designation; Option And Certification Labels - Detroit Diesel 60 Series Operator's Manual

ENGINE MODEL AND
SERIAL NUMBER
DESIGNATION
The engine serial number and model
number are stamped on the cylinder
block in the following location (as viewed
from the flywheel end):
Left side just below the intake mani-
fold and above the cast-in Detroit
Diesel logo. See Figure 1.
Option Labels
Computerized engine option labels are
attached to the valve rocker cover.
These labels contain the engine serial
number and model number and, in
addition, list any optional equipment
used on the engine. Labels also include
required tune-up information (injection
timing, valve lash, max. no-load RPM,
etc.). See Figure 2.
Figure 1. Location of Engine Serial and Model Numbers
With any order for parts, the engine
model and serial number must be given.
If a type number is shown on the option
label covering the equipment required,
this number should also be included on
the parts order.
Transmissions and power take-offs
generally carry their own name plates.
The model and serial number informa-
tion on these plates is useful when
ordering parts for these assemblies.
Certification Labels
If required, a certification label is
attached to the valve rocker cover. This
label certifies that the engine conforms
to federal and certain state emissions
regulations for its particular application. It
also gives the operating conditions
under which certification was made. See
Figure 2.
SERIAL NUMBER
MODEL NUMBER
1