Vacon optea Installation Manual page 83

Modbus TCP / Modbus UDP
Once the ID Map address range has been initialized with the parameter IDs, the parameter values
can be read and written in the IDMap Read/Write address range address (IDMap address + 100).
Table 34. Parameter Values in 16-bit IDMap Read/Write registers
If the ID Map table has not been initialized, all the fields show index as '0'. If it has been initialized,
the parameter IDs included in it are stored in the flash memory of the option board.
Table 35. Example of parameter values in 32-bit IDMap Read/Write registers
7.3.2.5.5. O
PERATION DAY COUNTER
Control unit operating time counter (total value). This counter cannot be reset. The values are read
only.
NOTE! The feature Operation day counter does not work with VACON
20 CP AC drives.
Operation day counter as seconds
This counter in registers 40011
unsigned integer.
Address
40011 High data
40012 Low data
Operation day counter
This counter in registers 40001
read only.
For compatibility with VACON
this counter is found from two different register areas: holding registers 40001
registers 1 to 5 .
d d
Local contacts: https://www.danfoss.com/en/contact-us/contacts-list/
Address
10601 Data included in parameter ID700
10602 Data included in parameter ID702
10603 Data included in parameter ID707
10604 Data included in parameter ID704
Address
10701 Data High, parameter ID700
10702 Data Low, parameter ID700
10703 Data High, parameter ID702
10704 Data Low, parameter ID702
to 40012 holds the value of operation days as seconds in a 32-bit
d d
Table 36. Operation days counter as seconds
Holds the counter value as seconds.
to 40005 holds the value of operation days counter. The values are
d d
®
100 family internal Modbus TCP/UDP and the OPT-CI option board,
Data
Data
® ®
20, VACON 20 X or VACON
Description
to 40005
d
vacon • 83
®
and input
d
7