Vacon optea Installation Manual page 53

Installation vacon • 53
Step 4. Press the "ON-LINE" button. The NCDrive will connect to the drive and start loading
parameter information. This will take a few minutes. See Figure 27 and Figure 28.
Figure 27. NC Drive: Going online
Figure 28. Loading information from the drive
Step 5. To change the option board settings, navigate to the "M7Expander boards" menu and select
the slot that the option board is connected to. You can change the IP address, network mask and
default gate address in the menu item "G 7.x". After you have changed the IP settings, you need to
change "IP Mode" to "Fixed IP" in order to activate the settings.
For more information about these settings, see Chapter 6.1 "Option board menu".
Local contacts: https://www.danfoss.com/en/contact-us/contacts-list/
5