Pc Tools For Vacon® 100 Family And Vacon® 20 / Vacon® Live - Vacon optea Installation Manual

vacon • 54
NOTE! The NCDrive software can be used with the Ethernet board in VACON
NOTE! The NCDrive software is recommended to be used in LAN (Local Area Network) only.
NOTE! This feature does not work with VACON
5.8.5 PC Tools for VACON
®
VACON Live can be used to configure all the settings of the OPTE9 option board. VACON
be downloaded from
To configure the IP settings of the OPTEA or OPTE9 option board, follow the steps below:
®
NOTE! VACON 20, VACON
connection over the OPTE9 Ethernet port. OPTEA does not support VACON 20
®
VACON 20 CP drives.
Step 1. Connect your PC to the Ethernet network with an Ethernet cable. You can also connect the
PC directly to the drive using a crossover cable. This option may be needed if your PC does not
support Automatic crossover function.
You can also connect to the VACON
below are the same for both connections.
NOTE! You cannot use VACON
address. If you change the IP settings of the option board when connected through it, VACON
connection will be lost.
5
Figure 29. NC Drive: OPTEA parameters
®
100 family and VACON
http://drives.danfoss.com
®
20 X and VACON
®
100 family AC drive by its serial port. In any case the steps
®
Live via the option board if the option board does not have a valid IP
Local contacts: https://www.danfoss.com/en/contact-us/contacts-list/
®
100 family AC drives.
®
20 / VACON
website.
®
20 Cold Plate do not support VACON
Installation
®
NXS and NXP drives.
®
Live
®
Live can
®
Live
® ®
, VACON 20 X and
®
Live