Vacon optea Installation Manual page 164

vacon • 164
Id
14
Instance
Services 0E
16
10
9.2.1.8.1.
Instance Attribute "Run1"
This attribute affects the run/stop behavior of the drive. See Table 132.
Instance Attribute "Run2"
This attribute affects the run/stop behavior of the drive. See Table 132.
Run1
0 -> 1
0 -> 1
1 -> 0
Instance Attribute "NetCtrl"
This attribute allows the network to request the run/stop control to be assigned to the network. If
the bit is 0, given control word is not updated to the drive. If the bit is 1, this means that the run/stop
control is requested to this network interface.
NOTE! The actual assignment of the run/stop control to this network interface is reflected in
attribute 15 .
d
Fieldbus control will not be forced on when this bit is set. You must change the control location
(fieldbus/IO/keypad) from the drive parameters.
Instance Attribute "State"
This attribute reveals the state of the device according to the following table. See also Chapter
"9.2.1.8.3. Control Supervisor State Machine".
9
Table 131. Control supervisor object
Name
5 Reset
d
Get_Attribute_Single
h
d
Set_Attribute_Single
h
I A
NSTANCE TTRIBUTES
Table 132. Run/Stop Event Matrix
Run2
0 0
0
0 0 -> 1
0 -> 1
1 1
1
1 1 -> 0
Resets drive to startup state.
Used to read single attribute value.
Used to write a single attribute value.
Trigger event
Stop
Run
Run
No Action
No Action
Run
Run
Local contacts: https://www.danfoss.com/en/contact-us/contacts-list/
EtherNet/IP
Description
Run type
N/A
Run1
Run2
N/A
N/A
Run2
Run1