Vacon optea Installation Manual page 41

Installation
Unless already done for the other control cables,
cut free the opening on the AC drive cover for the
fieldbus cable (protection class IP21).
NOTE: Cut the opening on the same side you
have installed the board in!
5
Remount the AC drive cover and run the cable as
shown in picture.
NOTE: When planning the cable runs, remember
to keep the distance between the fieldbus cable
and the motor cable at a minimum of 30 cm. It is
recommended to route the option board cables
away from the power cables as shown in the pic-
ture.
6
Local contacts: https://www.danfoss.com/en/contact-us/contacts-list/
vacon • 41
Fieldbus
cables
9202.emf
5