Vacon optea Installation Manual page 44

vacon • 44
Install the option board into the correct slot, D or E.
3
4
Close the option board cover.
Remove the cable entry plate. If you
installed the option board in the slot
D, use the cable entry plate on the
right side. If you installed the option
board in the slot E, use the cable
entry plate on the left side.
5
NOTE! The cable entry plate at the
bottom of the drive is used only for
mains and motor cables.
Open the necessary holes in the cable entry plate. Do not open the other holes.
6
See the VACON
5
D
®
100 X Installation Manual for the dimensions of the holes.
Local contacts: https://www.danfoss.com/en/contact-us/contacts-list/
Installation
E
11640_00
11641_00